AAccording to the production and processing sheet or design drawings to the rock plate market to select suitable for the production and processing sheet requirements or design requirements of the rock plate material. The less the texture pattern of the rock plate material is repeated, the greater the decorative effect, the more artistic and decorative, close to the texture effect of natural stone.

Plan the materials purchased. Which slabs are used to finish that area, how are the dimensions divided, how does the texture of the slabs go better, is it cut after grain.

Use dedicated typesetting software or AutoCAD to typeset the slab according to the production processing sheet or design drawing, and send the final effect of the typesetting to the customer for confirmation. The bridge cutting machine shall typesetting the drawing, and the operator shall not change the typesetting drawing and cutting the slab at will during the process of cutting the slab, otherwise it will affect the final installation effect of the slab, or lead to the poor effect of cutting the board or scrap the already cut slab.

In order to reduce the damage in the process of rock plate handling and transportation, the manufacturers of rock plate mostly use five-axis machining center cutting plate. The biggest advantage of the five-axis bridge cutting machine is that it can not only complete the cutting work of the rock board, but also complete the secondary processing of the product, which is impossible to achieve with the ordinary bridge cutting machine.

The cut rock slab on the machine must be washed clean with water, preferably clean water. If the surface of the slab is attached to the slab particles generated during the cutting process, the slab is likely to be fractured due to the gap between the slab and the slab when the two pieces are put together. After cleaning, use a rubber scraper or clean cloth to remove water from the surface of the sintered stone slab.

The processing staff inspects the finished product. Check the length and width of the product; Whether the shape or edge shape of the special-shaped plate of the secondary processing meets the requirements of the production processing sheet. The product inspector inspects the already processed products, focusing on checking whether the texture of the cut board meets the requirements of the layout diagram.